Tumble Dryer Heater Element - 2000W Stock Number: ES1435433
Genuine spare part for select models of Beko and Flavel tumble dryers
I have a DRCS 68W that is revolving and getting very hot but the clothes are just staying wet. Its like no air is circulating or something. I was hoping to find a fan or something as a part but none are listed. Not sure what part to replace, any ideas please?
- Thank you Chris, I had already cleaned the condensor and filter so I can eliminate that. The problem happened suddenly so i guess that also removes the filter from the suspect list. Thank you
-
Chris at eSpares says...
The belt goes round the outside of the drum down and around the motor spindle between the two belt tension wheels. These pinch the belt from either side to remove any slack and tension the belt.
-
Chris at eSpares says...
The part you refer to is not likely to be the problem. Dismantle the drier heater assembly on the top of the drum and check for signs of damage to the drier heater element.
-
Chris at eSpares says...
The first thing you need to do is check and clean the filter and the condenser at the bottom of the drier. Take the condenser out and flush warm water through to flush out any fluff or lint build up.
I have just ordered a new heater for the Beko DRCS68W. Looking at the back panel I'm unable to remove the cover that I think covers the heater as the panel has two pop rivets along with the screws holding the panel on. Do I have to drill out the rivets or 2 Answers
can I access the heater another way.
- Thankyou for the advice regarding the reset button on the blue wires!!
- The screws are all that holds the panel on - the panel will still come off with the rivets in place. Did you know the thermostat with the blue wires going to it has a reset button on it? I found out after I bought a replacement - not mentioned in the manual anywhare either!!
My drier appears to be working properly but it has no heat.Door closing drum rolling etc but no Herat.Disappointed as it is only 2 years old and not overused! 1 Answer
-
eSpares Staff at eSpares says...
It is likely to be the heater that has failed.
Does this heater unit come with the thermostat built in or do I have to get them separately ? 1 Answer
-
Dean at eSpares says...
We believe the thermostats are part of the element as shown in the photo attached to the part.
The little button on the heating element for my beko condenser dryer keeps tripping out after every use, its a brand new heating element. Any help would be great, many thanks 1 Answer
-
Dean at eSpares says...
There could be a number of reasons, please see our video for help http://www.espares.co.uk/advice/careandmaintenance/how-to-diagnose-tumble-dryer-drying-and-heating-problems
Hi replaced heating element and front thermostat on my beko drcs68w and still no heat what else can the problem be. Thanks
-
Chris at eSpares says...
Try cancelling the cycle by holding the cancel for 5 seconds then select a timed cycle and retry. If the machine did heat after the heater was replaced you still can damage the heater by turning off when hot. If this has happened try pressing the reset on the cut out mounted on the heater.
I know the heating element has gone when I checked it was clearly broken but there was a bang from the back and sometimes there is water residue when I clean the condenser. I can't turn it on because of the heating element as it shorts out, could it be something else. Thanks
-
Chris at eSpares says...
It is normal for water to be in the condenser, although it is unlikely to be other problems but we cannot guarantee this.
On our Beko DRCS 68W tumble dryer,there was a Big Bang from behind the drum and a electric burning smell. Any idea what this could be and what part I may need? 1 Answer
It came from the rear of the machine and I think that it may be the sensor although it looks fine.
-
Chris at eSpares says...
Check the mains filter, the motor capacitor and the dryer heater. We have videos on all of these in our Advice Centre: http://www.espares.co.uk/advice/9/2849 and http://www.espares.co.uk/advice/tumble-dryers?page=3
Just changed capacitor now I find it's not heating up,is it likely to be needing new heater as there are no reset button on this model
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to Diagnose Tumble Drier Drying and Heating Problems http://www.espares.co.uk/advice/9/2050
Hi I have a DRCT 70 that is moving but not heating up. Please can you advise me on what part I need please
-
Chris at eSpares says...
This could be a number of problems, for more information see: How to Diagnose Tumble Drier Drying and Heating Problems http://www.espares.co.uk/advice/9/2050/how-to-diagnose-tumble-drier-drying-and-heating-problems
Will this part fit my appliance?
Check Now