Pressure Washer Outlet Connection Cover Stock Number: ES538457
Genuine spare part for select models of Karcher pressure washers
this was caused by severe ffost
-
eSparesToby at eSpares says...
Have a look through our advice centre to see if there are any articles in there to help you out... Alternatively give the manufacturer a call for a diagnosis on the phone. Once you know exactly what part is at fault - give our team a call and they'll find the part for you.
I bought an extended pressue washer pipe which has a female fitting at both ends can I buy a male to male fitting which will enable me to connect to t 1 Answer
I require a male to male fitting to connect to the existing pressure pipe
-
eSparesMalindi at eSpares says...
Please contact the sales department with your full model details, hopefully they can help you. http://www.espares.co.uk/contactus.aspx
Wil this outlet fit my pressure washer, as the pressure hose keeps blowing off as soon as the power is switched on.
-
eSparesMalindi at eSpares says...
Please confirm the fault with the appliance before placing any orders. You may also need to check the model details of the appliance. This information can be found here: http://www.espares.co.uk/findingmodelnumbers.aspx
I have a kb4040 with a leak on the high pressure hose. Is the hose and gun one piece and do you have part number? 1 Answer
-
eSparesMalindi at eSpares says...
In order to answer this, please contact our call centre with the full model and chassis numbers of your appliance. For help getting the model information, please use this link: http://www.espares.co.uk/findingmodelnumbers.aspx
I have a k3.91. The part that the lance screws onto is letting water out through the seam joint. It is held in with a flat plate with 2 legs. Thank you
- yes pull the pin and remove but dont loose the o ring
-
Rory at eSpares says...
Hi Tantro, the gasket for this connection is this one: http://www.espares.co.uk/part/pressure-washers/karcher/p/1315/877/0/0/538186/karcher-pressure-washer-g.html?ms=6.362-151.0
I is the rubber gasket available that seals the Pressure Washer Connection to the injector? 1 Answer
What size is it? Regards Ian
-
Rory at eSpares says...
Hi Ickp2 In order to find the right gasket for your pressure washer I will need your specific model number. For help finding your model number, refer to our handy Finding Model Numbers guide here: http://www.espares.co.uk/findingmodelnumbers.aspx
I get water leaking between the outlet connector and the pump outlet. The outlet elbow seems fine - no cracks, and the o-ring also looks good. When I power up the elbow shifts forwards with the pressure and water leaks out. Any ideas, guys? (K3.86 model)
Will this part fit my appliance?
Check Now