Washing Machine Drum Bearing and Seal Kit Stock Number: ES481678
Genuine spare part for select models of Hotpoint, Creda and Gala washing machines
-
Chris at eSpares says...
Check your drum as we believe it is a 'welded drum' like Stock Number: ES865090. This does not have the row of bolts to allow the replacement of the bearings and requires a new drum complete.
-
Chris at eSpares says...
You should have a welded tub that has to be replaced complete see Stock Number: ES832942
HAVE JUST PURCHASED BEARINGS AND DRUM SEAL OF YOU BUT THE FRONT PANEL SEEMS TO BE SPOT WELDED. HOW DO I REMOVE THIS TO GET TO THE DRUM?
-
Chris at eSpares says...
On some later Hotpoint machines the cabinet is welded and the drum would have to be lifted out from the top of the cabinet or the machine placed on its side and the drum slid out. Remove any weights and motor before trying to lift out and lift with another person if possible.
I want to buy abearing kit for my Indesit WG1130D.Do I need a new drum seal as well if so is this included? 1 Answer
-
Chris at eSpares says...
In addition to this kit it is recommended you replace the tank seal Stock Number: ES488015.
I want to buy drum bearings for a hotpoint wm63. I have watched your video. Will I need a new drum seal as well and if so is it included 1 Answer
-
Chris at eSpares says...
It is wise to replace the tub gasket to prevent leaks when the drum has been split the part you need is Stock Number: ES101565
I need parts to replace drum bearings on a hotpoint wmd962 ultima do you supply these
-
Chris at eSpares says...
The bearings on your model may not be replaceable acording to the information we have as the drum used is glued together and cannot be separated see Stock Number: ES1128371. Check the joint between the front and rear parts of the tub, If there are not screws holding theses together every 100 to 150 mm then the whole drum will have to be replaced.
can you please advise if in your opinion I need new bearings or just a replacement rubber door seal. I have a hotpoint wm63 washing machine that when spinning has started making a loud rumbling sound. It doesn't make the noise when empty however when I pulled the machine out to look inside I have found that the doorseal is perished - would this be the cause. any help gratefully received.
-
eSparesMalindi at eSpares says...
We cannot give out technical advice unfortunately. Please speak to an engineer.
-
eSparesToby at eSpares says...
Unfortunately this isn't the right part for your appliance - we don't currently stock this for WMA63.
If you can how do you get to drum case apart to replace the bearings?
-
eSparesToby at eSpares says...
Unfortunately we don't stock this part for the WT540 model. Apologies and good luck with the hunt.
-
Rory at eSpares says...
Hi Kezo, as the suffix refers only to the colour of the washing machine, I can assure you this kit is the one you're after: http://www.espares.co.uk/part/washing-machines/indesit/p/1085/805/0/0/1016831/washing-machine-30mm-bear.html
Will this part fit my appliance?
Check Now