Dishwasher Power Supply Cable Stock Number: ES660391
Genuine spare part for select Bosch, Neff and Siemens dishwashers
Manufactured by Siemens
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Dishwasher Power Supply Cable
If the mains cable has come away from your dishwasher, leaving you with no means of using your appliance, then this spare part might just be your saviour. This power mains cable will fit to your appliance and ensure that it's always able to be fired up and started like a brand new machine.
Genuine spare part for select Bosch, Neff and Siemens dishwashers.
Please check the list of suitable models to ensure that this spare part will fit your appliance.
8 Questions and 7 Answers
-
Parminder at eSpares says...
This does not include the capacitor. We can only confirm compatibility through your model number. For help in finding your model number please see this link: www.espares.co.uk/findingmodelnumbers
Ob Bosch slimline Classixx dishwasher have traced a short circuit between live and earth to the respective terminals at the back of the white push-in plastic power assembly at bottom rear of the appliance. There is a deposit of conductive (1000 ohm between the terminals) pinkish jelly between those two terminals, also below it on floor of appliance, but not above it or anywhere else as far as I can see! Could this be electrolyte leakage from capacitor? ie if I replace the cable supply unit would that fix it or could it be food leakage from somewhere else nearby?
-
Chris at eSpares says...
It is possible this could be capacitor electrolyte that has leaked but this would usually show on the capacitor. check the one on the motor if fitted as this may be more likely to have caused the deposit.
Just purchased a Bosch dishwasher cable from yourselves. Stk no ES660391 it doesn't look like the one in the picture ie the cap is not on it. Tried it anyway and the machine runs but water doesn't seem to heat up. Could you help please. 1 Answer
-
Chris at eSpares says...
If the machine runs then there is not a problem with this filter. For information to diagnose your problem see our video: http://www.espares.co.uk/advice/3/2083/how-to-diagnose-dishwasher-leaking-and-heating-problems
-
Chris at eSpares says...
If you are referring to the mains suppressor for removing interference this is moulded on the other end of the cable from the mains plug.
The block has about 1 mm horizontal movement and no obvious clips to toggle.
-
Chris at eSpares says...
If you look carefully at the block you will see three wedges or claws that when pushed in spread behind the panel and secured it in place. These claws may be on both sides or a locating lip. Push the block to one side and using a flat blade under its edge try to prise the assembly out of the panel. If you can see the claws push them into the body to clear the hole.
Will this part fit my appliance?
Check Now
