Dishwasher Power Supply Cable Stock Number: ES660391
Genuine spare part for select Bosch, Neff and Siemens dishwashers
-
Parminder at eSpares says...
This does not include the capacitor. We can only confirm compatibility through your model number. For help in finding your model number please see this link: www.espares.co.uk/findingmodelnumbers
Ob Bosch slimline Classixx dishwasher have traced a short circuit between live and earth to the respective terminals at the back of the white push-in plastic power assembly at bottom rear of the appliance. There is a deposit of conductive (1000 ohm between the terminals) pinkish jelly between those two terminals, also below it on floor of appliance, but not above it or anywhere else as far as I can see! Could this be electrolyte leakage from capacitor? ie if I replace the cable supply unit would that fix it or could it be food leakage from somewhere else nearby?
-
Chris at eSpares says...
It is possible this could be capacitor electrolyte that has leaked but this would usually show on the capacitor. check the one on the motor if fitted as this may be more likely to have caused the deposit.
Just purchased a Bosch dishwasher cable from yourselves. Stk no ES660391 it doesn't look like the one in the picture ie the cap is not on it. Tried it anyway and the machine runs but water doesn't seem to heat up. Could you help please. 1 Answer
-
Chris at eSpares says...
If the machine runs then there is not a problem with this filter. For information to diagnose your problem see our video: http://www.espares.co.uk/advice/3/2083/how-to-diagnose-dishwasher-leaking-and-heating-problems
-
Chris at eSpares says...
If you are referring to the mains suppressor for removing interference this is moulded on the other end of the cable from the mains plug.
The block has about 1 mm horizontal movement and no obvious clips to toggle.
-
Chris at eSpares says...
If you look carefully at the block you will see three wedges or claws that when pushed in spread behind the panel and secured it in place. These claws may be on both sides or a locating lip. Push the block to one side and using a flat blade under its edge try to prise the assembly out of the panel. If you can see the claws push them into the body to clear the hole.
Does the lead come with the interferance suppressor as shown in picture. I note that the same question was requested some 8 months ago. No reply so far has been posted. I did phone the helpline to be informed that, what's in the picture is what you get.
-
Rory at eSpares says...
Hi Shootist, the interference suppressor is indeed included with the lead, exactly as pictured. Sorry for the tardiness of my reply!
Does this lead include the interferenc surpressor as shown in the picture? As I see it is listed as a seperate part at a higher price. 1 Answer
-
Rory at eSpares says...
Hi, this part comes exactly as pictured, including the interference suppressor.
Buying this part was needed for my Bosch dishwasher but it hasn't solved the problem as the RCD still trips. I suspect due to the original contact supressor blowing up it has damaged something in the dishwasher control module from further investigation I have done. With the unit NOT plugged into the mains there is 0 ohms across live and earth and maximum resistance across earth (not what you would like). When powered the earth from the back of the module and the plug are now connected and live & neutral give 240V (as you would hope). I assume that this the correct operation of this unit before I spend £100 on the control module?
Will this part fit my appliance?
Check Now