Tumble Dryer NTC Thermostat with Cable Stock Number: ES1331811
Genuine spare for select models of Beko tumble dryers
Manufactured by Beko
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Tumble Dryer NTC Thermostat with Cable
If your tumble dryer is just getting warm and not hot enough to actually dry your clothes, it could be due to a faulty thermostat and this could be the part for you. A working thermostat is vitally important in order to ensure that your dryer's temperature is constantly regulated. Grab this handy spare part and get your tumble dryer working like new again.
Specification:
- Cable Length: 700mm
Genuine spare part for select models of Beko tumble dryers.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
18 Questions and 20 Answers
Hi I have a Beko drcs68w and it dries clothes fine but it will not switch off I have it on the extra dry setting and always have also it will not let me choose another setting and bleeps when I turn the program knob on every setting except the extra dry setting I've also noticed when I turn the program knob to a different setting and do the reset it beeps on all settings except the the one I did the reset on what could be the problem please?
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to Diagnose Tumble Drier Drying and Heating Problems: www.espares.co.uk/advice/9/2050 It is possible the problem may be the board.
- i have replaced heatingunit and thermostat still not heating cleaned all vents and still no heat
-
Chris at eSpares says...
Moisture is detected by the metal strips of Stock Number: ES1567608 contacting damp clothes. If this is damaged or contaminated or the control board has failed it may show this problem.
Tried reset button. Also tried holding the 2 buttons for 3 secs. Checked the red clip is secure. Door is securely closed. All fuses are ok.
- Have just had this same fault on a Beco tumble dryer and there was a bad track on the main circuit board which I bridged with a thin wire and it is working again, don’t know if this is a temporary cure or not but only time will tell.
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to Diagnose Tumble Drier Control and Program Problems www.espares.co.uk/advice/9/2049
i have followed the video for another beko model but my dryer does not have the release bracket to allow access to the thermostat
-
Chris at eSpares says...
Replacement should be very similar to that shown in the video attached to this part.
I have replaced the heating element on my BEKO DRCS68W twice since the beginning of December but the same problem keeps occurring - the element is on for about 20 seconds and then it clicks off. It won't heat up again unless it's reset. Could this be a fault with the NTC rather than the heating element?
-
Chris at eSpares says...
If the covers are on and there is no blockage of air flow the heater should not cut out and would not need to 'cycle' for several minutes.
having took the back panel off, disconnected the lhs stat and found this was to earth. With this disconnected the dryer works but no heat. Is this a thermostat ?? only the lugs are smaller than the rhs resettable one, and will the replacement have to be a full element as the stats are not screwed on.
-
Chris at eSpares says...
This NTC is fitted at the front and is not a suitable replacement for your part. The thermostat you require is only available with the heater element.
Will this part fit my appliance?
Check Now
