Fan Oven Heater Element - 2300W Stock Number: ES655398
Spare part suitable for select models of Bosch, Neff and Siemens ovens
I've seen advice on other forums that suggests the existing earth wire should be connected to the fixing screws? Is that not necessary? 2 Answers
- The first answer is correct, but the earth wire should have its terminal insulated with tape or block and be tucked into one of the restraining clips on the harness, so that there is no static build up danger. The earth wire must not enter the oven space as this has now been classified differently by the relevant authorities. It is not satisfactory to connect it to the fixing screws of the element. This is why the terminal has been removed.
- This is not necessary as the oven body is earthed. I just covered the existing earth wire and tucked it down the back of the oven.
When I pulled the old duff element out, there was no spade attached to one side of the element, but two wires connected to each of two spades coming through the hole. One spade was attached to the element. I can't be sure whether the other spade was connected to the other leg of the same element connection or was actually free, and might have been connected to the other side of the element originally. I don't recall having to pull it off the element connector. There is insulating material in the hole where the element connections go through which meant the element didn't `dangle free' when the screws were removed. This material was hanging around the connections and may have pulled off one of the connections. Is it likely that these spades are actually one for each side of the element, or must I get the whole thing out to look from the other side?
-
eSpares Staff at eSpares says...
If one of the electrical connection has dropped off the element you will have to remove the oven to get the back panel off to gain access to the wiring, make sure the oven is disconnected before you attempt this.
The oven main fuse has blown on three occasions now for no apparent reason. I've noticed that when the grill element is turned on the oven element also comes on is this normal or a possible fault 1 Answer
Neff cooker model B1322N1GB/01
-
Chris at eSpares says...
On convection setting it is normal for a grill and a lower oven element to heat. On a fan setting it normally will only use a fan element.
-
Chris at eSpares says...
Check the dimensions and fitting match your element and if it is not clear they match use the original part.
Hi , my old element has a earth connector on it but my new element hasnt can i still use the new one and were do i put the earth connector on the oven 1 Answer
can i secure the earth wire to anything our can i just push it away
- Hi Colin, The element will earth through the m,ounting screws as long as they are tight and they screw into the main body (metal & earthed) of the oven. It always best to secure the earth cable if you are not going to use, so that it doesn't touch anything that it shouldn't. Good Luck
If the new Uk standards have only 2 connectors what do I do with the extra wire Ps I presume the connectors are colour coded brown live blue neutral
-
eSparesMalindi at eSpares says...
We cannot give technical advice unfortunately. Please speak to an engineer for support.
-
eSparesToby at eSpares says...
Give your manufacturer a call and find out the parts reference for the screws you need, then give our team a call to place your order.
Will this part fit my appliance?
Check Now