Dishwasher Water Flow Meter with PCB Stock Number: ES1562739
Genuine spare part for select models of Beko, Flavel, Lamona, Maytag, Belling, Whirlpool and Zanussi dishwashers
-
eSpares Staff at eSpares says...
The main PCB controls the amount of water required, the flow meter counts how much water is entering the dishwasher so the PCB no when to shut off the water valve and start washing the dishes.
Then empties and then keeps refilling until it floods the sump. I dried it all out and tried again. same thing only I turned machine off after about 50mins as water had reached the door seal. I turned off machine and pumped it out, only then did the machine beep and shut down. Prior to this the machine filled and stood idle, so I disconnected the flow switch and blew through and the wash began. all good until the above began. Could it be a faulty flow switch something else?
-
eSpares Staff at eSpares says...
You will need to check the pressure switch and chamber for a blockage before suspecting anything else.
-
eSpares Staff at eSpares says...
Yes, this part does connect to the regeneration unit.
Hi I have a Beko DWD4311W and after the program has finished there is a very small trickle of water coming in throught in fill point inside. 1 Answer
this is enough that over night it floods my kitchen. is this the flow meter? if not what part would it be? Many Thanks
-
eSpares Staff at eSpares says...
It is likely to be the inlet valve letting in water.
Lights go on - select program- makes whirring noise, empties but keeps whirring. Does not fill or wash
-
eSpares Staff at eSpares says...
If the dishwasher has not filled correctly it will not wash, please check out our helpful video www.youtube.com/watch?v=jLyA-7SC9ZY&t just copy and paste into your browser.
BEKO DE2542FW dishwasher - the start/stop switch will not switch it off. Pump runs as soon as on switch pressed. Pumps out but does not progress. 1 Answer
-
eSpares Staff at eSpares says...
You will need to test the switch but also check the base as if it has leaked the anti-flood will activate continually pumping.
I selected a programme, pressed start and the green wash light comes on with the sound of operation and is on constantly. Cycle does not progress. The only way to stop it is to either open the door and leave it open or switch off at the plug. Help !!
-
Chris at eSpares says...
Water under the cavity will cause the pump to run continuously. See our advice centre for dishwasher diagnosis information.
Mt beko dwd5411s dishwasher doesn't heat up, ive changed the flow through heater and the thermostat but it still isn't working. Could it be the control panel and if so can these be replaced? 1 Answer
-
Chris at eSpares says...
The control panel Stock Number ES1570285 could be responsible for the problem with your dishwasher.
-
Chris at eSpares says...
I this does not detect the water flowing into the machine it may cause the machine to shut off and show a filling error.
Will this part fit my appliance?
Check Now