Washing Machine Cold Water Double Inlet Solenoid Valve Stock Number: ES1249572
Replacement spare part for select models of Beko washing machines
Water is going in and the drum is turning but after 3 or 4 minutes the IE error code comes up. All pipes are clear and water is going in easily. Everything else seems to be working including the spin.
-
eSpares Staff at eSpares says...
have a look at our diagnosing video for help www.youtube.com/watch?v=QYPqpjLV7s4&t just copy and paste into your browser.
WM7335w is not filling up with water, checked pipes all ok, did diagnostics in test mode and water does go through the soap dispenser. could it still be the inlet solenoid? 1 Answer
-
Chris at eSpares says...
Enter 'Diagnose filling problems washing machines' in our advice centre for information on your problem.
when start washer it makes a humming sound an will not fill cleaned filter an checked pipes an still wont fill please help im lost without my washing machine
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to diagnose washing machine dispenser and filling problems http://www.espares.co.uk/advice/7/1825/
the dispenser looks fine
-
Chris at eSpares says...
If water is dispensed into the pre wash and main wash compartments there is not likely to be a fault with this valve. If the softener is not being flushed into the machine replace the dispenser top.
BEKO WMB61221S
-
Chris at eSpares says...
Check the dispenser top for mould as this is the usual cause. To check the valve select final rinse and partially open the draw. If water flows into more than one compartment then the valve is likely to be ok. Note your machine may perform two rinses and this will only occur on the final rinse.
when setting wash at 102 machine stops at 25 have to press start button several times and stops again at 19 have to press start button several times befor finishing wash 1 Answer
-
Christopher at eSpares says...
to check this valve start a pre wash program and check water is filling through the drawer pre wash compartment. Then do the same on wash checking the main wash drawer compartment. The fault you describe is likely to be either a drain problem (should empty from full in less than 45 seconds) or a heating problem (check the heater element).
can hear when its supposed to stop and then start turning or whatever but just continues to fill with water.
Will this part fit my appliance?
Check Now