Dishwasher Main PCB Module Stock Number: ES1244889
This is a genuine spare part for select Amica, Flavel, Howden, Leisure, lamiona, Beko and Diplomat dishwashers.
Can you tell me if this PCB board already programmed with the necessary software or is it blank? 1 Answer
I have a Beko Integrated DW600. Machine is not heating the water up. Engineer has checked everything else and said it can only be down to needing new pcb board. Just need to know if this board is already programmed as if it is not and it’s blank then it would be cheaper for me just to purchase a new machine.
-
eSpares Staff at eSpares says...
The manufacturer service site does not say this part needs to be programmed.
I have a lamona hja8630. Stays hot after the cycle. Seems to be the control board. Does the control board need programming (the how to video said some models require this) or is this simply a job of replacing the board? 1 Answer
-
eSpares Staff at eSpares says...
The manufacturer site does not say this part needs to be programmed.
Got power to dishwasher.All the right lights are on.But when shut door to commence washing ,nothing happens apart from 3 clicks in the door panel in the area of the on off switch 1 Answer
-
Dean at eSpares says...
For information on this problem see our diagnosis video How to Diagnose control and programme problems with a dishwasher: www.espares.co.uk/advice/3/1985
My dishwasher starts the cycle but only gets so far then stops and I end up with water in the bottom of the dishwasher? 1 Answer
Beko DW600
-
Chris at eSpares says...
For information on this problem see our diagnosis video How to Diagnose control and programme problems with a dishwasher : www.espares.co.uk/advice/3/1985
-
Chris at eSpares says...
Check it is not connected to a hot water supply. If it fills cold and heats suspect this control board.
Having problems with my Beko Dw600. I can select a program for various temperatures but the cycle won't start when I press the play button. The button itself isn't broken. I got it started earlier by holding the buttons down for various lengths of time, but I had the same issue a few days ago.Would this be a problem with the PCB? I clean the dishwasher regularly so it shouldn't be a problem on this end. Any info would be appreciated.
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to Diagnose control and programme problems with a dishwasher. http://www.espares.co.uk/advice/3/1985/how-to-diagnose-control-and-programme-issues-with-a-dishw
-
Chris at eSpares says...
Check if the pump is continually running as the machine may be in anti flood mode. If this is the case tip over or remove the base to clear the water and retry.
ES1244889 is this the printed circuit board that fits inside the door to operate the controls? There is no image so I just wanted to check. 1 Answer
-
Rory at eSpares says...
Hi there, this printed circuit board sits behind the dishwasher's control panel, which operates the control knobs. Check out this video to get a look: http://www.espares.co.uk/advice/dishwashers/a/3/1287/how-to-replace-a-hotpoint-dishwasher-fascia-p.html
Will this part fit my appliance?
Check Now