Cooker Hood Halogen Bulb & Housing Assembly Stock Number: ES919684
Genuine spare part for select Belling and Stoves cooker hoods
Manufactured by Belling
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Cooker Hood Halogen Lamp and Housing
If your cooker is in need of a new lamp, then you've come to the right place. This handy genuine spare part, might just be what you need to restore your cooker to full working order so you're able to cook with ease once more. Order this spare today and get cracking with those delicious meals again in next to no time at all.
Specification:
- Cap: G4
- Type: Halogen
- 20 Watts
- Volt: 12V
- Colour: Clear
Genuine spare part for select Belling and Stoves cooker hoods.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
4 Questions and 5 Answers
- The lamp does come apart to fit new bulbs. As the other commenter has said, slide a knife or small screwdriver in the circular gap between the metal outer housing and the metal ring holding the glass. Lever it out on one side and you can then repeat it around the slot to pull out the glass lens in it's holder. The bulb is then a simple pull out and replace. Pushing the lens holder back in is a bit awkward because you have to line up cut outs but it just takes some trial and error. I'm buying the whole lamp because I couldn't work this out originally either, and tried pulling the whole lamp unit down, bending the sprung tabs holding it in place. It's never been the same since. Note to Belling if they read this: why not just put these instructions and pictures in the manual for the cooker hood and save us all this hassle??
- One original bulb failed after only a few months use. I replaced it with a standard inexpensive G4 12volt 20 watt halogen capsule. It has been going for the past two and a half years and gives similar light to the original bulb. I removed the glass lens by by sliding a paring knife under the metal rim and the old bulb pulled out and the new one slotted in easily. The specs of the bulb are embossed on the reflector, btw. Do NOT remove the whole light assembly, it is held in by two springs that deform so it doesn't clip back. If you do you will have to buy another light unit or dismantle part of the hood to get the thing back in and it's very fiddly to put back together. I am not an electrician, so please understand that I have described what I did and do not recommend any course of action.
-
Chris at eSpares says...
This assembly looks like it uses a standard bulb like Stock Number: ES676581 but we are not able to confirm if the lamp comes apart to remove this bulb.
Where can the instructions for replacing this housing, and replacing the halogen bulb, be found please? 1 Answer
-
Chris at eSpares says...
The old assembly just needs the spring clip that fixes it to the hood to be squeezed in and allow it to pass back through the mounting hole.
I have 3 glass bulb covers broken on my belling extractor. as a result the bulbd themselves do not last very long. Do you stock just the glass covers? 1 Answer
-
Chris at eSpares says...
In order for us to source the exact part you require please provide us with the following information: Appliance make, model and serial number of your appliance. For further help visit the "Finding Model Numbers" page on our website here: http://www.espares.co.uk/findingmodelnumbers. Alternatively please copy and paste this link into your web browser.
I replaced 1 of the bulbs and it only lasted 3 weeks, the other has now gone do you have any info as to why they are blowing? Before it blows it goes on and off intermitantly and with a tap comes back on, do these earth on the hood?
Will this part fit my appliance?
Check Now
