Washing Machine Electronic Control Module Stock Number: ES213453
Genuine spare part for select Candy and Hoover washers
Manufactured by Hoover
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Washing Machine Electronic Control Module
The PCB is the 'brains' behind your washer's programming and a faulty board may render your appliance useless. If you've found your washing machine is flashing error codes or not selecting certain wash cycles, this handy little spare might just be what you need to rectify the problem.
Genuine spare part for select models of Candy and Hoover washers.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
5 Questions and 4 Answers
Can it be the module fault? Thermo sensor is OK Thermostat is OK
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to Diagnose a Faulty Washing Machine Heater www.espares.co.uk/advice/7/1794
Wash cycle seems OK,spin also seems OK.Drum appears to drain OK.The TOC's are not tripped.The drying temp raises but no rotation from drum.
-
Chris at eSpares says...
Depending on your model the problem may be the dryer module or the main power module. Without replacement it may not be possible to confirm which is faulty.
The machine fills and empties but the drum doesn't turn at all, i.e, no wash or spin action. Have you got any suggestions?
-
Chris at eSpares says...
For information to diagnose your problem see our video: http://www.espares.co.uk/advice/7/1730/how-to-diagnose-washing-machine-motor-problems
hoover nextra 7 - Model No HNF7167-80
-
Rory at eSpares says...
Hi Austin, this is a strange one. If you haven't already, I'd clean the lint filter (situated at the bottom of the front of the washing machine. If there's definitely no blockages whatsoever in the hoses, then there could well be an electrical fault on the PCB, or in the wiring leading off from the PCB. Unfortunately, there's no easy way of confirming this. First off, make sure that the terminals are all securely fitted to both the PCB and all the mechanisms in the machine they lead off to. If they are all secure, try looking for visible signs of damage on the PCB, the terminals or the wire.
programmer works OK, connections seem OK, brushes OK.
Will this part fit my appliance?
Check Now
