Tumble Dryer Relay/PCB (Printed Circuit Board) Stock Number: ES209751
Genuine spare part for select models of Candy, Hoover and Maytag tumble dryers
Manufactured by Hoover
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Tumble Dryer Relay/PCB (Printed Circuit Board)
If your tumble dryer is flashing with error codes and refusing to select certain wash cycles, it may be time to replace your PCB board. Once fitted to your appliance you should be able to select the drying cycle you require and get your clothes dried up in a jiffy.
Genuine spare part for select models of Candy, Hoover and Maytag tumble dryers.
Please check the model fit list to ensure compatibility with your appliance.
12 Questions and 14 Answers
Model no. VHV 180
- Check the thermal cut outs on the top of the heater as they have probably failed. The heater will probably require replacement as I dont think the cut outs are available for this model.
- There is no heat , does this mean I will need a new tumble dryer relay/pcb ( printed circuit board ) ? And if so, is it easy to fit ?
-
Chris at eSpares says...
Check if any heat is felt in the drum when it stops as there may be a heater fault.
every time i switch my tumble dryer (CANDY cc2-270) on.... it seems to trip my fuse box out....... i was going to buy the relay which is avalable on this site ...... please could anyone help .... :(
- my hoover tumble had the same symptoms - i replaced the relay but it still tripped the mains. Turned out to be a burned out motor causing a direct short circuit one of the windings.
-
eSparesMalindi at eSpares says...
Sorry we cannot give out technical advice unfortunately. Please contact an engineer for support.
Hoover Model HLV8LCG-80 tumble dryer No Heat. I tested the Heater and thermostats that are attached to the heater and they are fine. Any suggestions please.
-
eSpares Staff at eSpares says...
you would need to test the rest of the dryer heating circuit to eliminate any issues with the wiring but it is likely to be the PCB, check this video for more help www.youtube.com/watch?v=trJXdqNBn7M&t just copy and paste into your browser.
Changed heater element and still blowing cold air....everything else works as it should, cleaned all fluff and condenser
-
Chris at eSpares says...
If the water in the base has not drained to the container it may shut off the heating to prevent leaking and damage. Check the pressure switch under the drum.
I HAVE A CREDA CONDENSER DRYER AND WHEN I TURN IT ON IT CLICKS OFF AFTER ABOUT 10 SECONDS.
-
Chris at eSpares says...
Check if there is a fault with the heater as this may be the problem.
Will this part fit my appliance?
Check Now
